Power Meter – Din Rail No Display

This three phase multi-function power meter with Modbus/RTU output is simple to install and easy to configure directly into a remote display or into your data acquisition system.

Monitoring power consumption will give you a clear indication of the energy and cost of running your compressed air system. This power meter measures voltage, amps, kilowatts, power factor, kilowatt hours, kilovolt amps and harmonics. It can be installed on mains supply or used for sub metering individual equipment or sub loads.

Installing power meters on compressors is not difficult but should be done by suitably qualified and experienced technicians. Some knowledge of MODBUS communications is required to connect the power meters to your network

The unit comes with 3 rogowski coils current transducers. Rogowski coils have a large flexible coil and are an excellent solution where a traditional current clamp is too difficult to fit. The coil is shielded against the influence of external magnetic fields and is suitable for high power load analysis. Coils can be fastened by cable ties for permanent installs.

Best suited to

• Where no display is required
• 3 phase or single phase measurements
• Temporary or permanent installations
• DIN Rail mounting

Key features of the Power Meter

• Multi-function meter
• Measure single or three phase power with the same meter
• DIN rail mounting
• Modbus/RTU output
• Easy to install rogowski coil current transducers
• Measures Voltage, Amps, Kilowatts, Power factor, Kilowatt hours, Kilovolt Amps and harmonics
• 3 rogowski coil current rating options
• Can be installed on mains supply
• Can be used for sub metering individual equipment or sub load
• 12 month warranty

Options for the Power Meter

• Rogowski Coil current rating – 500 amps, 1,000 amps or 3,000 amps

Contact us for other Rogowski Coil sizes.

Warranty

12 month warranty

Other Information

Part Numbers: POM100100, POM100200, POM100300