Pressure Sensor – 16 bar (232 psi)

Pressure sensor can be used to measure pressure loss across the compressed air and gas system. This easy to install pressure sensor is perfectly suited for installation on compressed air and gas systems. It can be installed on both wet and dry gases up to 16 bar (232 psi). The sensor has 4-20mA or Modbus output.

For effective measurements, you will need at least:

• one (1) pressure sensor on the wet side of the system to monitor compressor output and
• one (1) on the dry side of the system to measure the system supply pressure.

Other pressure sensors can be installed to measure pressure drop at key locations such as near any high compressed air or gas consumers and at the far ends of the system.

Best suited to

• Demand, Supply and Remote installations
• Dry or Wet Gas
• Permanent or temporary installation

Key features of this Modbus Pressure Sensor

• Pressure range: 0-16 bar (232 psi)
  • If you need a pressure sensor with a higher pressure range, up to 50 bar (725 psi), see our other pressure sensor.
• Easy to install and wire
• Stainless Steel Casing
• Two output options:
  • 4 – 20mA loop powered output
  • Modbus Output
• 24vDC powered
• IP67 rated
• Operating range between: -30°C to +80°C
• M12 Connector with 5m Cable option
• 12 month warranty

Modbus Pressure Sensor comes with:

• Calibration certificate
• User Manual
• 12 month warranty

Modbus Pressure Sensor Options

• 5 meter data cable

Warranty & Calibration

12 month warranty

Calibration is recommended every 2 years (provided the sensor is not exposed to relative humidity above 85%).
Annual calibration is required if the sensor is exposed to relative humidity above 85%.

Accessories

Accessories such as mechanical and electrical fittings are available.

Other Information

Part Numbers: PRE110001, PRE110002